Use the measurements provided below for the length of plastic plates and construct average and range control charts. The target length is 20 mm and a tolerance of +/- 0.06mm. There are 10 batches in total with 5 made on Monday and the remaining 5 made on Thursday by different individuals on a CNC machine. The measurements have been taken using a Vernier calliper. Students must submit an individual report that should contain the following: 0 The mentioned control charts (ii) Suitability and discussion of control chart findings Calculation of a new tolerance if the current tolerance is not satisfactory (iv) Significance of process capability with literature v (v) Any other control charts that could be drawn from this data and discussion about their suitability 1 2 1 2 3 4 5 6 7 8 9 10 20.19 20.13 20.17 20.03 20.09 20.14 20.13 20.13 20.13 20.13 20.21 20.09 20.15 20.18 20.05 20.13 20.16 20.14 20.12 20.11 20.13 20.09 20.14 20.11 20.09 20.11 20.12 20.01 20.12 20.13 20.1 20.12 20.12 20.07 20.09 20.13 20.13 20.13 20.14 20.11 20.09 20.08 20.08 20.13 20.11 20.14 20.14 20.11 20.13 20.15 3 4 5