value: 5.00 points Problem 6-17 Some tasks and the order in which they must be performed according to their assembly requirements are shown in the following table. These are to be combined into workstations to create an assembly line. The assembly line operates 7.5 hours per day. The output requirement is 675 units per day PRECEDING TIME PRECEDING TIME TASK TASKS (SECONDS) TASK TASKS (SECONDS) 25 23 18 F, G 21 20 10 J, K a. What is the required workstation cycle time to meet the desired output rate? Workstation cycle time b. Balance the line using the longest task time based on the 675-unit forecast, stating which tasks would be done in each workstation. (Leave no cells blank be certain to enter "O" seconds per unit wherever required.) Work Station Task Idle Time (Click to select) (Click to select) (Click to select) (Click to select) Ill V (Click to select) Vi (Click to select) c. What is the efriciency of your line balance, assuming it is running at the cycle time determined in part a? (Round your answer to 1 decimal place.) Efficiency d. After production was started, Marketing realized that they understated demand and must increase output to 775 units. What action would you take? (Round your answer for cycle time down to the nearest whole number. Round your answer for overtime up to the nearest whole number.) (Click to select) cycle time to seconds or work minutes of overtime References Worksheet Difficulty: 3 Challenge Problem 6-17 Learning Objective: 06-04 Understand how to design and analyze an assembly line