Viscosentyo? Two thin 22cm16cm fiat plates are separated by a 2.5mm ditance and are being pulled horizontally in cpposite directions at the constant velochies shown in the Table below, through an overall 8mm thick fluid layer, which is contained between two walls, as shown in the Figure below. The top wall is moving with a constant velocity, while the bottom wall is stationary. The fluid used is Glycerin 640C. You must: a) Use the engineering method to solve this problem. (4 marks) b) Draw the velooty profile through the entire 8mm thick fluid layer. (7 marks) (Note: draw neatly and at least one third the size of an A4 theet of paper containing all relevant datz) c) Determine the location(s) in the fluid tayer where the velocity is zero. (3 marks) (Note: make sure to reference where the location(s) are being measured from? d) Determine the componeots of force. F1, and the total force. F1, that needs to be applied to the top thin flat plate to maintain its constant motion for the scenario shown in the Figure below. ( 6 marks) (Note: remember sign convention for your answer) ANSWER: The total force F1 is N