We want to read the value from the PIND and make the five outputs through the PORTB in sequence. We assume the reading value from the PIND is in binary,00101100 ($2C in hex). the output through PORTB will be different based on the value changes of the register R16 that we load the value of PIND reading to this register R16 as followings; Write a code to make this operation using I/O registers and IN/OUT instruction. You cannot run the part (1) code due to the input reading operation. Therefore, you can use another instruction to do the same operation such as LDS. Write a code using alternative instruction to run the operation and to observe the output value at the PORTB. Check the operation using ATMEL STUDIO 7 simulation and demonstrate your result. We want to read the value from the PIND and make the five outputs through the PORTB in sequence. We assume the reading value from the PIND is in binary,00101100 ($2C in hex). the output through PORTB will be different based on the value changes of the register R16 that we load the value of PIND reading to this register R16 as followings; Write a code to make this operation using I/O registers and IN/OUT instruction. You cannot run the part (1) code due to the input reading operation. Therefore, you can use another instruction to do the same operation such as LDS. Write a code using alternative instruction to run the operation and to observe the output value at the PORTB. Check the operation using ATMEL STUDIO 7 simulation and demonstrate your result