what are the steps for this in Matlab? I put the first couple data pieces but together all the data is more than 1000 points so could you walk me through the code for this and show me how to load the data? the work I have on matlab it shows everything but it won't stop populating the graph

 

Problem 2 Background When performing experiments, sometimes it is necessary to filter data to obtain accurate results. Define You are an aerospace engineer performing an experiment in a wind tunnel. You are recording the dynamic pressure of the air flowing across an airplane wing as you increase the air velocity over time. This dynamic pressure will always be greater than 0 as long as the air is moving. Pressure.txt contains the measured values of dynamic pressure as a function of time. The first column is the time in seconds and the second column is the pressure in pascals (Pa). When you look at the data you notice a problem. The first fifty points of the data are what you would expect. However, from the fifty-first point on your equipment occasionally malfunctioned. In the places where it malfunctioned the equipment stored a 0.0000 for the pressure. You must process the data, removing the 0.0000 values and the corresponding time value, and then plot the original data and new data on the same graph. Plot pressure on the y-axis and time on the x-axis. You must compare the mean and standard deviation of the new and old data. Also, you must compare the number of data points in the new and old data, to determine how many points were corrupted.