What's the answer?

You are a network administrator for a medium-sized company. After receiving reports about network performance issues, you decide to inspect the interface statistics on one of your Cisco switches. You notice the presence of collision-related counters incrementing in the output shown below. router#show interface ethernet0 ethernet0 is up, line protocol is up Hardware is Lance, address is 0010. 7b36. 1be8 (bia 0010. 7b36. 1be8) Internet address is 10.200.40.74/22 MTU 1500 bytes, BW 10000 Kbit, DLY 1000 used, reliability 255/255, txload 1/255, rxload 1/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Half Duplex, 10 Mops, media type is RJ45 ARP type: ARPA, ARP Timeout 04:00:00 Last input 00:00:00, output 00:00:06, output hang never Last clearing of "show interface" counters never Input queue: 1/75/1/0 (size/max/drops/flushes); Total output drops: 0 Queueing strategy: random early detection (RED) Output queue: 0/40 (size/max) 5 minute input rate 1000 bits/sec, 2 packets/sec 5 minute output rate 0 bits/sec, 0 packets/sec. 2058015 packets input, 233768993 bytes, 1 no buffer Received 1880947 broadcasts, 0 runts, 0 giants, 1 throttles 3 input errors, 0 CRC, 0 frame, 0 overrun, 3 ignored 0 input packets with dribble condition detected 298036 packets output, 32280269 bytes, 0 underruns 0 output errors, 10 collisions, 0 interface resets 0 babbles, 1 late collision, 143 deferred 0 lost carrier, 0 no carrier 0 output buffer failures, 0 output buffers swapped out Referencing the above from that switch, which of the following is the MOST likely cause of the collisions on this Ethernet network? A speed mismatch exists between connected devices. The interface is set to full-duplex mode. The interface is set to half-duplex mode, while the connecting device is in full-duplex mode. The interface MTU size is set too low. C G Search or type URL + # $ % 3 4 5 6 7 8 9 O