When a NO Start PB is pressed momentarily and the NC Stop PB is not pressed then the Motor will turn on (S1 on) to move boxes down the conveyor, the Motor will turn off(Sol 1 off) when the Stop PB is pressed. (1)The boxes come in two sizes, large and small, they are sent to either Pallet 1 or 2 to be shipped out.There are two limit switches that detect the size of the box Part LS1 and Part LS2. Ifthere is a Small box then only LS1 will be activated and LS2 wont be activated, if there is a Large box then both LS1 and LS2 will be activated.There is a Break-Make pushbutton that decides where the different size boxes are diverted to.oIf it is not pressed, then Large boxes go to Pallet 1 and Small boxes to Pallet 2.oIf it is pressed, then Small boxes go to Pallet 1 and Large boxes to Pallet 2.Cylinder Control Double Acting Cylinder, Double Acting Control ValveThe Cylinder extends (Sol 2) to push boxes onto Pallet 2 if the Break-Make PB is not pressed and it detects a Small box. (2)Or the Cylinder extends to push boxes onto Pallet 2 if the Break-Make PB is pressed and it detects a Large box. (2)The cylinder will retract as soon as it is fully extended.Complete the following:2 Truth tables and Logic Fundamental Diagrams - for Sol1(2), and Sol 2 (2)Pneumatic schematic (1) and European electrical schematic.