White Company has two departments, Cutting and Finishing. The company uses job-order costing and computes a predetermined overhead rate in each department. The Cutting Department bases its rate on machine-hours, and the Finishing Department bases its rate on direct labor-hours. At the beginning of the year, the company made the following estimates: Direct labor-hours Machine-hours Total fixed manufacturing overhead cost Variable manufacturing overhead per machine-hour Variable manufacturing overhead per direct labor-hour Required: 1. Compute the predetermined overhead rate for each department. Department Cutting 8,400 63,600 Finishing 87,000 3,600 $ 512,000 0 0 $2.75 $ 380,000 $ 2.00 2. The job cost sheet for Job 203, which was started and completed during the year, showed the following: Direct labor-hours Machine-hours Direct materials Department Cutting Finishing 5 88 19 4 $ 710 $ 110 $ 380 $ 418 Direct labor cost Using the predetermined overhead rates you computed in requirement (1), compute the total manufacturing cost assigned to Job 203. 3. Would you expect substantially different amounts of overhead cost to be assigned to some jobs if the company used a plantwide predetermined overhead rate based on direct labor-hours, rather than using departmental rates? Answer is not complete. Complete this question by entering your answers in the tabs given below. Required 1 Required 2 Required 3 Compute the predetermined overhead rate for each department. Note: Round your answers to 2 decimal places. Cutting Department Finishing Department Predetermined overhead rate $ 7.97 per MH per DLH Required 1 Required 2 >