White Company has two departments, Cutting and Finishing. The company uses a job-order costing system and computes a predetermined overhead rate in each department. The Cutting Department bases its rate on machine-hours, and the Finishing Department bases its rate on direct labor-hours. At the beginning of the year, the company made the following estimates: Department Direct labor-hours Machine-hours Total fixed manufacturing overhead cost Cutting 7,400 56,000 Finishing 84,000 2,200 $ 380,000 $ 459,000 Variable manufacturing overhead per machine-hour Variable manufacturing overhead per direct labor-hour $ 3.00 $ 3.75 Required: 1. Compute the predetermined overhead rate for each department. 2. The job cost sheet for Job 203, which was started and completed during the year, showed the following: Direct labor-hours Machine-hours Direct materials Direct labor cost Department Cutting 3 Finishing 19 85 4 $ 360 $ 380 $ 760 $ 60 Using the predetermined overhead rates that you computed in requirement (1), compute the total manufacturing cost assigned to Job 203. 3. Would you expect substantially different amounts of overhead cost to be assigned to some jobs if the company used a plantwide predetermined overhead rate based on direct labor-hours, rather than using departmental rates? Required 1 Required 2 Required 3 Compute the predetermined overhead rate for each department. (Round your answers to 2 decimal places.) Predetermined overhead rate Cutting Department per MH Finishing Department per DLH Using the predetermined overhead rates that you computed in requirement (1), compute the total manufacturing cost assigned to Job 203. (Round your intermediate calculations and final answer to 2 decimal places.) Total manufacturing cost