WRITE THIS ONLY IN JAVA PROGRAM. DO NOT USE C++. Can you use command code to talk about the code. Thank you! (Please have the code match the bar graph )

The current-voltage characteristic or I-V curve is a relationship, typically represented as a chart or graph, between the electric current through a circuit, device, or material, and the corresponding voltage, or potential difference across it. You are given a MOSFET device with the following I-V curve: 50 er 30 20 4 V 3 V 2 V 10 10 Drain to source voltage [V] After properly biasing the device, you then proceed to take measurements of the drain current at key drain to source voltages when the gate to source voltage is set to produce a response corresponding to the VGs-VTH-7V line. The recorded measurements are given in the table below: VDs ID 13 25 4 40 57 59 Based on these measurements, write a program to recreate the associate I-V curve. Your program should sweep through values for Vos starting from 1 and ending at 8 with steps of 0.25. Use the same method for interpolating between two values as was done in assignment 2. For each Vos value, create a bar chart that displays the relative value of ID as shown in the next image MOSFET Drain Current vs Drain to Soure Voltage 1.25 1.50 1.75 2.00i 2.25 2.50 2.75 3.00 3.25 3.50 16.0 19.0 22.0 25.0 27.0 29.0 31.0 33.0 34.75 36.5 4.25 4.50 4.75 5.00 5.25 42.125 44.25 46.375 48.5 50.625 5.50 5.75 6.00 6.25 6.50 6.75 7.00 7.25 7.50 7.75 8.00 52.75 54.875 57.0 57.25 57.5 57.75 58.0 58.25 58.5 58.75 59.0 The output from your program should be exactly the same as the above image. Note: . To produce the line underneath the title, print (char)0x2501 several times using a for loop To produce the horizontal line next to the Vds values, print (char)0x2507 To produce the bars in the graph, print (char)0x2588