Question: Redo Problem 5.28 using Aspen Plus. Problem 5.28 The inlet to an adiabatic turbine is steam at 1.3 MPa and 385 C, and the

Redo Problem 5.28 using Aspen Plus.

Problem 5.28

The inlet to an adiabatic turbine is steam at 1.3 MPa and 385◦C, and the turbine exit pressure is 0.1 MPa. 

a. Determine the maximum work that can be obtained from each kg of steam and the exit temperature of the steam. 

b. If the turbine has an isentropic efficiency of 80%, determine the work obtained per kg of steam and the exit temperature.

Step by Step Solution

★★★★★

3.39 Rating (165 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

Problem Statement An adiabatic turbine is fed with steam at 13 MPa and 385C The turbine exit pressur... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Chemical Biochemical And Engineering Questions!

Q:

The inlet to an adiabatic turbine is steam at 0.8 MPa and 350 C, and the turbine exit pressure is 0.1 MPa. a. Determine the maximum work that can be obtained from each kg of steam and the exit...

Q:

The inlet to an adiabatic turbine is steam at 1.3 MPa and 385C, and the turbine exit pressure is 0.1 MPa. a. Determine the maximum work that can be obtained from each kg of steam and the exit...

Q:

The vortex tube (also known as a Ranque or Hirsch tube) is a device that produces a refrigeration effect by expanding pressurized gas such as air in a tube (instead of a turbine as in the reversed...

Q:

Question 1 A steam power cycle with regeneration as shown below on the T-s diagram employs a single open feedwater heater for efficiency improvement. The fluids mix with each other in an open...

Q:

5-180 Determine the power input for a compressor that compresses helium from 150 kPa and 20C to 400 kPa and 200C. Helium enters this compressor through a 0.1-m2 pipe at a velocity of 15 m/s. 5-181...

Q:

ONLY NEED PROBLEM 3 PROCESS AND ANSWER!!! Reference are all given and the thermodynamic tables are below: https://drive.google.com/file/d/1M7Tf2e6TPPkppq02XIqCyMJqfZUGMZzF/view?usp=sharing Problem 1...

Q:

Redo Problem 5.25 using Aspen Plus. Problem 5.25 Repeat the calculation of problem 5.23 if the compressor has an isentropic efficiency of 87%. Problem 5.23 Repeat the calculation of problem 5.22 with...

Q:

Redo Problem 6.32 using Aspen Plus Problem 6.32 Repeat the calculations of Problem 6.13 if the mechanical efficiency of the adiabatic turbine is only 85 percent. Problem 6.13 Eighteen kilograms of...

Q:

Redo Problem 5.24 using Aspen Plus. Problem 5.24 Repeat the calculation of problem 5.22 if the compressor has an isentropic efficiency of 72%. Problem 5.22 Isobutane is to be liquefied to make liquid...

Q:

Redo Problem 13.32 using Aspen Plus. Problem 13.32 Liquid benzene can be catalytically hydrogenated, with cyclohexene, cyclohexane, and 1,3-cyclohexadiene being among the products. Determine the...

Q:

You have the following information on a project's cash flows. The project's required rate is 12.5%. Year Cash flows 0 -$89,000 1 26,000 2 28,000 3 37,000 4 69,000 The project's profitablity index is...

Q:

A typical loud sound wave with a frequency of 1 kHz has a pressure amplitude of about 10-4 atm. (a) At t = 0, the pressure is a maximum at some point x1. What is the displacement at that point at t =...

Q:

Describe two of the Help features available in QuickBooks Accountant.

Q:

=+3. Prepare a classified balance sheet as ofJuly 31, 2009.

Q:

An object starts with an initial velocity of 3 m/s at t = 0, and it accelerates with an acceleration of a(t) = 7t m/s 2 . Find the total distance the object travels in 4 s.

Q:

The equation for the voltage (t) across a capacitor as a function of time is where i(t) is the applied current and Q 0 is the initial charge. A certain capacitor initially holds no charge. Its...

Q:

A certain objects acceleration is given by a(t) = 7t sin 5t m/s 2 . Compute its velocity at t = 10 s if its initial velocity is zero.

Q:

Provide at least 5 topics related to business research.

Q:

Do Homework: Chapter 6 Homework Score: 62.75%, 10.67 of 1 7 pts E6-23A (similar to) LIFO

Q:

Vigin Australia Airtines is considering the purchase of a new machine that will allow customers to check-in faster when it intends to resume international flights to Europe, the US and Asia from...