The catalytic hydrogenation of methyl linoleate to methyl oleate was carried out in a laboratory-scale slurry reactor

Question:

The catalytic hydrogenation of methyl linoleate to methyl oleate was carried out in a laboratory-scale slurry reactor in which hydrogen gas was bubbled up through the liquid containing spherical catalyst pellets. The pellet density is 2 g/cm3. The following experiments were carried out at 25°C: Run Partial Pressure of H2 (atm) Solubility of H2 (g mol/dm3) H2 Rate of Reaction (g mol/dm3 • min) Catalyst Charge (g/dm3) Catalyst Particle Size (μm)13 2 18 3 3 0.007 0.042 0.007 0.014 0.014 0.007 3.0 0.5 1.5 12 50 50

a. It has been suggested that the overall reaction rate can be enhanced by increasing the agitation, decreasing the particle size, and installing a more efficient sparger. With which, if any, of these recommendations do you agree? Are there other ways that the overall rate of reaction might be increased? Support your decisions with calculations.
b. Is it possible to determine the effectiveness factor from the data above? If so, what is it?
c. For economical reasons concerning the entrainment of the small solid catalyst particles in the liquid, it is proposed to use particles an order of magnitude larger. The following data were obtained from these particles at 25°C:Run Partial Pressure of H (atm) Solubility of H2 (g mol/dm) H Rate of Reaction (g mol/dm min) Catalyst Charge

The Thiele modulus is 9.0 for the 750-μm particle size in run 4. Determine (if possible) the external mass transfer coefficient, kc, and the percent (of the overall) of the external mass transfer resistance to the catalyst pellet.

Fantastic news! We've Found the answer you've been seeking!

Step by Step Answer:

Related Book For  book-img-for-question
Question Posted: