Question: State one condition under which the error signal of a feedback control system would not be the difference between the input and the output.

State one condition under which the error signal of a feedback control system would not be the difference between the input and the output.

Step by Step Solution

★★★★★

3.35 Rating (173 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

OK lets use an example Say you have an autonomous car It has the a... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Students Have Also Explored These Related Control Systems Engineering Questions!

Q:

The block diagram of a feedback control system is shown in Figure P8.12(a).The transfer functions of the blocks are represented by the frequency response curves shown in Figure P8.12(b).

Q:

The block diagram of a feedback control system is shown in figure. Determine the values of Kc that result in a stable closed-loop system.

Q:

A feedback control system is shown in Figure P8.8.The specification for the closed-loop system requires that the overshoot to a step input be less than 15%. (a) Determine the corresponding...

Q:

1.What are the similarities and differences between alluvial and deltaic sedimentary 1deposition? How might rocks from alluvial and deltaic environments differ? 2.How do continental shelves build up...

Q:

% Demonstration of Cruise Control % Using PI (Proportional and Integral) Controller % % Task: Complete and run the script. % The places you need to add code start with a capitized word. clear all;...

Q:

i need to solve this 4 sections using matlab thank you 1 Introduction 1.1 Plant Transfer Function The transfer function of the pitch angle, (), of a ship to elevator deflection 6,(), is given by by...

Q:

Design and Build a DC Motor Control System Using Simulink Blocks - Exam Question: A DC motor drives a factory conveyor belt system, and its speed needs to be controlled to ensure consistent product...

Q:

Design and Build a DC Motor Control System Using Simulink Blocks - ExamQuestion:A DC motor drives a factory conveyor belt system, and its speed needs to be controlled toensure consistent product...

Q:

Exercise 4. Roll control under periodic disturbance (10pt) Consider the feedback loop represented in Fig. 1 where 1 P(s) = S is the normalized transfer function of a body rotating around one of its...

Q:

Question 1 A system built with sensor is Not yet answered Marked out of 1.00 P Flag question o open loop control system computer control system O Manual control system O Feedback Control system...

Q:

Contrast applied research and basic research.

Q:

Which of the following topics would be addressed in the management representation letter? A. All financial records have been made available to the auditor. B. Documentation exists for all financial...

Q:

What were Apple's total long - term liabilities ( non - current liabilities ) on September 2 4 , 2 0 2 2 ? What was the increase / decrease in Apple's total long - term liabilities from the prior...

Q:

Explain the occasional correlation between a private equity fundraising and valuation levels for their private equity investments.

Q:

Write each answer with a reasonable number of figures. Find the absolute and percent relative uncertainty for each answer. (a) [12.41 (0.09) 4.16 ( 0.01)] 7.068 2 ( 0.000 4) = ? (b) [3.26 (0.10) ...

Q:

How many milliliters of 53.4 (0.4) wt% NaOH with a density of 1.52 ( 0.01) g/mL will you need to prepare 2.000 L of 0.169 M NaOH? (b) If the uncertainty in delivering NaOH is [1] 0.01 mL, calculate...

Q:

(a) How many milliliters of 53.4 (0.4) wt% NaOH with a density of 1.52 ( 0.01) g/mL will you need to prepare 2.000 L of 0.169 M NaOH? (b) If the uncertainty in delivering NaOH is [1] 0.01 mL,...

Q:

What are spot rates and forward rates? Purple Whale Foodstuffs Inc., a U.S. company, produces and exports industrial machinery overseas. It recently made a sole to a Japanese manufacturing firm for...

Q:

There are four principal decision models for evaluating and selecting investment projects: Net present value (NPV) Profitability index (PI) Internal rate of return (IRR) Payback period (PB) Which...

Q:

Fill the blue blanks Part B Using today's actual financial statements (Year 0) and the assumptions given, please forecast the missing items in the Income Statement, Balance Sheet and the Free Cash...