Venable, Inc., a manufacturer of snowmobiles, has just received an offer from a supplier to provide 3,000

Question:

Venable, Inc., a manufacturer of snowmobiles, has just received an offer from a supplier to provide 3,000 units of a component used in its main product. The component is a _ track assembly that is currently produced internally. The supplier has offered to sell the track assembly for $64 per unit. Venable is currently using a traditional, unit-based costing system that assigns overhead to jobs on the basis of direct labor hours. The estimated traditional full cost of producing the track assembly is as follows:image text in transcribed

Prior to making a decision, the company’s CEO commissioned a special study to see whether there would be any decrease in the fixed overhead costs. The results of the study revealed the following:
3 setups—$1,350 each (The setups would be avoided, and total spending could be reduced by $1,800 per setup.)
One half-time inspector is needed. The company already uses part-time inspectors hired through a temporary employment agency. The yearly cost of the part-time inspectors for the track assembly operation is $12,300 and could be totally avoided if the part were purchased.
Engineering work: 515 hours, $30/hour. (Although the work decreases by 515 hours, the engineer assigned to the track assembly line also spends time on other products, and there would be no reduction in his salary. )
260 fewer material moves at $35 per move.
Required:
1. Ignore the special study, and determine whether the track assembly should be produced internally or purchased from the supplier.
2. Now, using the special study data, repeat the analysis.

3. Discuss the qualitative factors that would affect the decision, including strategic implications.
4, After reviewing the special study, the controller made the following remark: “This study ignores the additional activity demands that purchasing would cause. For example, although the demand for inspecting the part on the production floor decreases, we may need to inspect the incoming parts in the receiving area. Will we actually save any inspection costs?” Is the controller right?LO1

Fantastic news! We've Found the answer you've been seeking!

Step by Step Answer:

Related Book For  book-img-for-question

Introduction To Cost Accounting

ISBN: 9780538749633

1st International Edition

Authors: Don R. Hansen, Maryanne Mowen, Liming Guan, Mowen/Hansen

Question Posted: