Question: A current of 0.6 A flows through a resistor with a voltage difference of 120 V across it. What is the resistance of this resistor?

A current of 0.6 A flows through a resistor with a voltage difference of 120 V across it. What is the resistance of this resistor?

Step by Step Solution

★★★★★

3.26 Rating (167 Votes )

There are 3 Steps involved in it

1 Expert Approved Answer
Step: 1 Unlock

Rearrange equation I VR for R ... View full answer

blur-text-image
Question Has Been Solved by an Expert!

Get step-by-step solutions from verified subject matter experts

Step: 2 Unlock
Step: 3 Unlock

Document Format (2 attachments)

PDF file Icon

1575_60619c5a78770_745798.pdf

180 KBs PDF File

Word file Icon

1575_60619c5a78770_745798.docx

120 KBs Word File

Students Have Also Explored These Related Physics Everyday Phenomena Questions!

Q:

If a current of 0.10 A flows through a resistor and the potential drop across the resistor is 1.5 V, what is the resistance?

Q:

Three 20- resistors are connected in series to a 6-V battery of negligible internal resistance. a. What is the current flowing through each resistor? b. What is the voltage difference across each...

Q:

Three resistors of 3 , 6 , and 2 are connected in parallel with one another. What is the equivalent resistance of this combination?

Q:

A current of 0 . 6 A flows through a resistor with a voltage difference of 1 2 0 V across it . What is the resistance of thisresistor?

Q:

1) A charge of 15 10 6 C is located 21 cm from a charge of 7 10 6 C. NOTE: This is a multi-part question. Once an answer is submitted, you will be unable to return to this part. Determine the...

Q:

Consider the following circuit: R3 = 4 . 10V la] Find the equivalent resistance of the circuit. lb] What is the value for the current through each of the resistors? (c) Calculate the power dissipated...

Q:

-6 4. A copper wire has a diameter of 5.0 mm and cross-sectional area A = 2.0 x 10 m. It carries a current of 3.5 A. The resistivity of a copper is 1.72 x 10-8 Q2m. Find: (i) The magnitude of...

Q:

A 8 0 Ohm resistor has a voltage difference of 1 2 V across its leads. ( a ) What is the current through the resistor? ( b ) What is the power being dissipated in this resistor?

Q:

1. How would you measure the voltage across a light bulb?| 2. How would you measure the resistance of a light bulb? 3. Determine the equivalent resistance when a 15 0 and 41 0 resistor are connected...

Q:

second bulb + Vbat A The voltage across the battery Vis 8.00 V. A connecting wire runs from the battery to the first bulb. A second connecting wire runs from the first bulb to the second, and a third...

Q:

0 Assignment Question for Chapter 3: PROBLEM 3-14 High-Low Method; Scattergraph Analysis [LO2] Travis Metals heats copper ingots to a high temperature by placing them in a large oven. The heated...

Q:

Refer to Exercise 16. Use the Tukey-Kramer procedure to identify which average purchases differ. Use a 95% level of confidence. In exercise The owner of a drugstore is wondering whether the amount of...

Q:

If a dictionary is stored in spam, what is the difference between the expressions 'cat' in spam and 'cat' in spam.keys ( ) ? Question 4 0 options: The first checks if 'cat' is a key, the second if...

Q:

Visit the website www.egurucool.com. Comment on its navigation, page template and content. What is the objective of the site? How many clicks does it take on an average to go to any link? What is the...

Q:

Fig. 6.61 shows an alternate scheme for biasing the NE5234 output stage . Ignoring all base currents, find |I C74 | I C75 . Use Fig. 6.42 for the relative emitter areas of all the transistors except...

Q:

Determine the small-signal voltage gain of the NE5234 if all the values of all the resistors in the input stage are doubled. Assume the common-mode input voltage is low enough that Q 1 and Q 2 are...

Q:

In Fig. 6.31b, resistive loads were used to extend the common-mode input range to include V EE . Fig. 6.62 shows another circuit with this characteristic. Find the common-mode range of this circuit....

Q:

prove the following propositions: I need both items thanks 3. Let X1, X, ,. . . random variables lid, with exponential distribution A = 1. Show that Xn P( >liv.) = 1 Xn log n P( >2i.v.) = 0 log n but...

Q:

Q3 One of the most common mistakes by new SAs is confusing functional and non-functional requirements. Visit the Amazon.com site. Give an example of a functional business requirement and an example...

Q:

Write three hundred thirty thousand and fourteen hundredths in numerals