1) INTERRUPT GPIO Question for STM32F051R8T8 MCU a) Configure the required conditioning using the STM Cube Ide program to set the frequencies of 48MHz cpu, 48Mhz APB1 Timer Clocks and 24Mhz APB1 Peripheral Clocks using 8Mhz internal xtal. In response, share a photo from the Clock Configuration tab of the STM Cube Ide program. b) b) Write the program code that flashes the LEDs connected to the port pins PCO to PC3 in relation to the 4 buttons connected to the port pins PC6 to PC9, using interrupt in the buttons section. c) After the button is pressed and pulled, keep the relevant led on for the duration of the hold, then write the function that turns off. 1) INTERRUPT GPIO Question for STM32F051R8T8 MCU a) Configure the required conditioning using the STM Cube Ide program to set the frequencies of 48MHz cpu, 48Mhz APB1 Timer Clocks and 24Mhz APB1 Peripheral Clocks using 8Mhz internal xtal. In response, share a photo from the Clock Configuration tab of the STM Cube Ide program. b) b) Write the program code that flashes the LEDs connected to the port pins PCO to PC3 in relation to the 4 buttons connected to the port pins PC6 to PC9, using interrupt in the buttons section. c) After the button is pressed and pulled, keep the relevant led on for the duration of the hold, then write the function that turns off