1. (TCO 4) The dynamic updating of a routing table is done by _____. (Points : 2)

a routing protocol a static route the spanning tree protocol All of the above

Question 2.2. (TCO 4) To show the OSPF process ID you would enter what command? (Points : 2)

show route table show process ID show ip OSPF process ID display

Question 3.3. (TCO 4) How does the BDR know that the DR has failed? (Points : 2)

The DR stops sending Hello packets. The DR stops sending keep alive frames. The BDR asks the DR each minute. The hop count increases.

Question 4.4. (TCO 4) What is a requirement of the reference bandwidth in OSPFv3? (Points : 2)

It prevents the router from automatically adjusting the bandwidth. It should be the same on all routers in the domain. It is set to 1 Gb/s by default. It increases the speed of the link.

Question 5.5. (TCO 4) Why might you use the ip ospf priority command with OSPF? (Points : 2)

To provide a back door for connectivity during the convergence process To influence the DR/BDR election process To streamline and speed the convergence process To activate the OSPF neighboring process

Question 6.6. (TCO 4) The OSPF hello and dead intervals are configurable per _____. (Points : 2)

OSPF process ip protocol interface router

Question 7.7. (TCO 4) To force a router priority change to take effect on a router, this command can be used. (Points : 2)

clear ip ospf process clear priority reset dr reenable router process

Question 8.8. (TCO 4) To propagate a default route configured with OSPF, the _____ command is used.(Points : 2)

ip route redistribute routes default-information originate inner route