1- The 8086 microprocessor 13es ------signal to support the direct memory access in maximum mode. 2. The --------represents the action that the processor must execute; while therwluch defines the source of the data to be operated on 3 The enable or disable certain S086 operations. 4- 8085 is an 8 bt microprocessor it can address up to - + byte of memory 5- The 8085 microprocessor uses the --------- Register to store the instruction fetched from the memory -13 a 16-bit register printing to data in stack segment. sigeral sx used to indicate whether the operation is belongs to the memory or periphernis, 8- The - signal helps to capture the lower onder address presented on the multiplexed adultese data 9. ------can be used to store the lo address and string manipulation 10. When the --------- signal is active, il indicates to the other processors not to mark the CPU to leave the system bus 11-On receipt of an INTR intemupt signal, the microprocessor accepts the interrupt by activating the signal) 12-On receipt of the - signal, the microprocessor leaves on the control of the buses, 13- In 8085 microprocesit the time required to execute and fetch an entire instruction is called ----- 14-----s a 16-bit register. Used in conjunction with the ES register int string operations 15- The BIL in 8086 perform the following tasks 16. The --pin is an edge trigeered inpait, which cauas an interrupt request to the microprocessor 17-8086 Microprocessor supports --------- modes of operation 18-The input in 8086 Microprocessor is examined by a -WAIT instruction 19. The signals provide the status of instruction queue. 20- The information is stored in the ---------during the manufacturing process