1. The objective of simulation is to verify and optimize the design. Simulation can idealize a circuit. The objective of measurement is to experimentally confirm the specifications. Measurements must consider all non-idealities.

a. Describe completely the definition of the Common Mode Rejection Ratio (CMRR) of an operational amplifier. Recommend a circuit to measure the CMRR. Use MULTISIM to conduct the measurements of CMRR. Provide the plot of the CMRR (in dB) versus Frequency (Hz) to prove the efficacy of the OPAMP.

b. What do you understand by the term slew rate of an operational amplifier? Recommend a circuit to measure this parameter and provide complete measurement of this parameter using the MULTISIM environment.