105 Prncram numhar n1n11 (Fimura in 21 int rigure 10.27 Print and tool paths for producing the part for 10.5. Setup Notes: 1. Set X0Y0 at the lower left-hand corner. 2. Z0 is the top of the part. 3. For inside machining, the part is held by two clamps against three pins. 4. For outside machining, shop the machine. Clamp the part from the inside and remove the outside clamps and pins. Clamp Setup Notes: 1. Set X0Y0 at the lower left-hand comer. 2. Z0 is the top of the part. 3. For inside machining, the part is held by two clamps against three pins. 4. For outside machining, shop the machine. Clamp the part from the inside and remove the outside clamps and pins. Outside machining I NEED TO KNOW HOW TO FIND THE POINTS \#2 AND \#11 PLEASE