10.Capacitor Output Filter a) Diode Rectifier - No DC Load Inductor Configure the Test Set for full wave three phase SCR rectifier operation with a 2200 uF and 150Q) resistor load. Slowly energise the system to 100V,,; AC input with a firing angle of 0 (diode mode). Measure the average DC output voltage and compare it against the ideal theoretical value for continuous conduction. Capture waveforms of the quantities V, Ig, Ipc. Explore in particular the waveform of Iy over several fundamental cycles. Is this current continuous or discontinuous? Examine Vyy carefully, and compare it against V. Are the four notches in these voltages identified in Section 8(a) still present? REPORT ANALYSIS: Explain the waveform of Iy, including in particular the reasons for deviations in magnitude of successive pulses within a fundamental cycle. REPORT ANALYSIS: Explain why the four notches in Vgy are no longer present with this load configuration