1a. Configure the hostname for your routers; R1 should be renamed the CLIDLANA and R2 should be renamed CLIDLANB. Screenshot the router prompts and command used to configure the routers hostname.

1b. Configure the gateway address for FastEthernet 0/0 and the FastEthernet 0/1 interfaces on Router R1. Use the IP address and subnet mask specified in Table 1. Screenshot the router prompts and command used to configure the interfaces.

1c. Configure the gateway address for FastEthernet 0/0 and the FastEthernet 0/1 interfaces on Router R2. Use the IP addresses and subnet mask specified in Table 1. Screenshot the router prompts and command used to configure the interfaces.

1d. Use the proper command to verify that the router interfaces are properly configured. Screenshot the router prompt and command used to verify the interfaces.

1e. Configure an EIGRP route from the LAN-A router to the LAN-B router. Use an autonomous system number of 100. Screenshot the router prompt and command used to configure EIGRP routing.

1f. Screenshot the router prompt and command used to verify that EIGRP routing has been configured on the LAN-A router. Are there routes configured to all the networks?

1g. Use the computers in each LAN to ping the computers in the adjacent LAN.

1h. Use the proper command to trace the route from a PC in LAN-A to a host in the LAN-B. Your trace should pass through two routers. List the command used and record the trace information. How may hops did you record?

1i. Use the command to list the eigrp neighbors off the LAN-A router.

Reference Tables For convenience, Table 1 provides the IP address and mask of all necessary interfaces used to complete the lab Table 1: The Computer IP Addresses, Subnet Masks, and Gateway Address for Lab 6 Computer/Interface - R1 IP Address 192. 1 68.2118 192.168.21.17 10.30.1.1 IP Address 192.168.85.21 192.168.85.18 10.30.1.2 Subnet Mask 255.255.255.240 255.255.255.240 255.255.255.252 Subnet Mask 255.255.255.240 255.255.255.240 255.255.255.252 Gateway Address PC1 R1-Fa0/1 R1-Fa0/(0 Computer/Interface - R2 192.168.21.17 Gateway Address 192.168.85.18 PC2 R2-Fa0/1 R2-Fa0/0 The commands used in these labs are based on the following: Router: Cisco IOS Version 12.4(7h) Switch: Cisco OS Version 12.2(25) Detailed Lab Steps In the following tasks, you demonstrate your knowledge to configure computer networks. Each task specifies a particular network setting you will be required to input. You will be required to document the command(s) used to accomplish each task. Task #1 In this lab you configure EIGRP routing to the adjacent LAN for the network shown in Figure 1. You are required to verify that computers in your LAN can ping the neighbor LAN