2- Assign the IP addresses in the following table to the network devices. Note: Router0 from PC0. Use set passwords in the previous steps. (1 point) The correctness of IP addresses depends on your choice of interfaces between the networking devices. You must figure out the correct value of the Default Gateway. (3 points) 7- Change the name of Router0 to "Main" from PC0. You must proof the name change with a screenshot from the router. (1 point) 8- Verify the connectivity between PCO and PC1 by running a command from both PCs that traces the route from each PC to the other. Explain the result of the run command (i.e., Can the PCs communicate over the network or not? Is there a difference between the responses or not? and why?). ( 1 point) 3- Set the static routs for both networks of PCO and PC1 on Router0. The commands must be written in Router0. (1 point) 4- Set Router0 as the next hub for the network of PC1 from Router1. The command must be written in Router1. (1 point) 5- Set Router1 as the next hub for the network of PC0 from Router2. The command must be written in Router2. (1 point) 6- Enable the secret password " qqu " for the privileged execution mode in Router0. Set the password "cisco" on VTY lines 0 and 1 on Router0. Telnet