2. This question is about Workholding for Machining: Describe the workholding of the part below (identical to the Part in Question 1 above), for the machining ONLY of (1) the top surface of the cylindrical section of the part (as highlighted), and the (2) corresponding large through-hole. [8 points] You must draw and label all the components of the fixture/jig you propose. You must show heights of locators where needed (though, no dimensioning is needed). You must show all the directions of machining and clamping. State all your assumptions clearly. YOU MUST USE THE FIGURE BELOW IN ORDER TO DRAW YOUR PROPOSED FIXTURE/JIG AROUND IT. Good Luck! 3 of 7 pages