(3). In the diagram below: a. There are three vlans, vlan 10, vlan 20 and the default vian (vlan ) b. Vlan 10 has a network address of 192.168.5.0/24 c. Vlan 20 has a network address of 192.168.6.0/24 d. The default vlan, vlan 1 has a network address of 192.168.7.0/24 e. The router has three ports, G0/1, G0/2 and G0/3 f. Both switches have the same configuration and the following have already been done: 1. Vlan 10 and vian 20 have already been created. L. Ports FO/1 to FO/5 have been assign to vlan 10 i Ports F0/6 to F0/10 have been assign to vlan 20 iv. Ports G0/1 and G0/2 are on the default vian (vlan 1) & In both switches, four PCs are already connected to Port FO/1, F0/2, F0/6 and Fo/7. h. The two switches are connected using a cross-over cable via Port G0/1 G0/2 G0/1 G0/3 Router Port G0/1 Port FO/1 to Port Fo/s Port Fo/6 to Port FO/10 Port G0/2 PC PC PC PC Cable connecting the two switches Port FO/1 to Port Fo/s Port FO/6 to Port F0/10 Port G0/1 Port G0/2 PC PC PC PC PC PC PC PC Question 3 (cont.) Refer to the diagram on the previous page Your next task is to use network cable(s) to connect the router to the switched network using the router on a stick option. The router has not been configured yet. 1(A) Describe how are you going to connect the router to the switched network. What kind of cable? FROM which port and on which device TO which port and on which device? 1(B) Assume you are now in the Router's CLI (Command Line Interface) with Global Configuration Mode, write down the configuration command you will do for interface G0/1 1(C) What needs to be done on port G0/1 in the two switches in order to support the above switched network 1(D) After a year, you want to add one more switch of similar model and set-up to the network. Describe how could this be done. S W Cu