4. The heat engine shown below is a series of steady flow devices connected in series to generate mechanical power in a cycle. Specifically, water is the working fluid and a source of high-temperature energy is used to transfer heat into the working fluid to in P = 100 bar T = 520C www Power out Turbine P = 0.08 bar *2=90% -2 generator Steam 4 P = 100 bar 7 =43C Condenser Cooling water in at 20C Pump 3 P3 0.08 bar Power in Saturated liquid Cooling water out at 35C generate steam. The high- enthalpy steam is then fed into the turbine to extract mechanical work. All heat engines are limited to the 2nd Law of Thermodynamics in that all the high-temperature heat transfer CANNOT go to mechanical work in the cycle. Rather, most of the energy will be transferred out to the surroundings by heat to bring the working fluid back to the original state and keep the cycle going. Use the diagram & given values to analyze this steam heat engine: (a) What is the heat rate into the water working fluid at the steam generator stage (boiler, 4-1) if the water mass flow rate is 109 kg/s? (b) What is the work output power at the turbine 1-2? (c) What is the isentropic efficiency of the turbine stage? (d) What is the heat transfer out of the water working fluid at the condenser stage 3-4? (e) What is the mass flow rate of the cooling water at the condenser stage assuming the heat capacity for liquid water is constant at c = 4.184 kJ/kg/K? (f) What is the work input power at the compressor stage? (g) What is the isentropic efficiency of the pump stage? (h) How does the net power output compare to the high-temperature heat transfer that comes into the cycle?