95q should be used instead of 0.q kN. Question 3-A=only compute by hand. for question. 3-B= you have to take a screen shot of ansys solution.thats all ??

W Tutorial Assignment 2 (100 marks, weighted 10%) 301022 ACAE Question 3: 2-D CST Element Method (50 marks) A cantilever is 200 cm long, 30 cm high and 5 cm thick, and is attached to a wall with full fixity at its left end (i.e., no rotations allowed). The figure below shows an elevation and cross section view of a cantilever beam subject to an end moment couple of 10 kN + 0.q kN forces, in which q is the last two digits of your student ID, spaced at 30 cm centres. The beam is made of steel and its modulus of elasticity E and Poisson's ratio v are 210 GPa and 0.3 respectively. Fx = 10 kN + 0.q kN 30 cm Fx = 10 kN + 0.q kN 5 cm 200 cm CROSS - SECTION ELEVATION VIEW Use two CST elements to create a finite element model of this cantilever beam and finish two tasks: A) compute by hand or use MS EXCEL to determine: a) the nodal displacements at each node; b) the reactions at the support; c) the strain and stress in each element; B) conduct this finite element analysis employing ANSYS and report the results compared to the solutions obtained in Part A