A 10-story building elevator has 3 different speed levels. These are Slow, Fast and Very Fast. If the button is pressed from the elevator up or down from inside the car and more than 2 floors and calls come from the higher floors or downstairs during this time, the elevator will go to the relevant floor for 2 seconds with slow speed and then very fast. If a call comes from the floors that are 2 floors and 1 floors high or from the lower floors, it will go to the relevant floor firstly for 2 seconds slow speed and then fast. If the call comes when the elevator is traveling in a very fast position, it will first switch to the fast mode and then it will switch to slow speed half a meter before the relevant floor. If the elevator does not receive a call for 2 minutes, it will go to the ground floor and wait there. The elevator will answer calls in the same direction while going up, or will not answer calls in the opposite direction while going down, and will answer when traveling in that direction, or will answer that call after it is finished. There is a contact that checks whether all landing doors are open or not, and there is also 1 contact on the car door. While the elevator comes from below for the relevant floor, 1 magnet comes from above, 1 magnet and 1 magnet at the floor level. If the elevator will not go to that floor, it will not read those magnets. If there are these and similar features, you should take into account the features you will add, naming the ENTRY Addresses and EXIT Addresses, and make the automation of the 10-storey building's elevator with PLC and draw the relevant LADDER diagram