Access List activity 1 - Standard Access Lists On the network shown below, the following is needed: Allow the Management network to access the Server network Allow the Desktops network to access the Management network Block the Desktops network from accessing the Server network PC5 -Desktops 192.168.42.0/24- PC6 2911 Router 1 -Management 192.168.242.0/24- Server2 Servers 172.16.14.0/24- 1. Write out the necessary standard access control lists to achieve these goals Permit/Deny Source Interface Direction Rule Name 2. Using Packet Tracer: Build the network as described Configure the network and assign address everything. The router interfaces should all be the first available address in each network (.1) The desktops and servers can be any other valid IP It is not necessary to assign addresses to the switches Validate connectivity to/from each PC and Server 3. Apply the access control lists to packet tracer and verify functionality Test connectivity via PING to/from each network. Confirm the results match the stated needs at the top. Source Desktop Desktop Management Management Server Server Destination Server Management Desktop Server Desktop 4. Submit a document with: Management The ACL table from step #1 The running config from your router PING?