Question
a)Configure the IP addresses as: - Host A: 10.1.1.1/24. Gateway: 10.1.1.3 - Host B: 10.1.1.2/24. Gateway: 10.1.1.3 - R1s G0/0: 10.1.1.3/24 - Host C: 10.3.3.3/25.
a)Configure the IP addresses as:
- Host A: 10.1.1.1/24. Gateway: 10.1.1.3
- Host B: 10.1.1.2/24. Gateway: 10.1.1.3
- R1s G0/0: 10.1.1.3/24
- Host C: 10.3.3.3/25. Gateway: 10.3.3.1
- R1s G0/1: 10.3.3.1/25
- S1: 10.2.2.1/24. Gateway: 10.2.2.3
- S2: 10.2.2.2/24. Gateway: 10.2.2.3
- R2s G0/0: 10.2.2.3/24
- R1s S0/3/0: 10.4.4.1/30
- R2s S0/3/0: 10.4.4.2/30
Check that you can ping between hosts in the same subnet:
- From Host A to Host B.
- From Host C to R1s G0/1 interface.
- From S1 to S2.
- From R1s S0/3/0 interface to R2s S0/3/0 interface.
Note that you cant ping between hosts in different subnets because the routers dont have any entry in their routing table.
b)- Enable OSPF/RIP in all interfaces both R1 and R2 (area 0) with only one subcommand in the OSPF/RIP configuration.
Check that the neighboring relationships have been created between R1 and R2.
Check that, after configuring OSPF/RIP, you can ping between hosts in different subnets.
- From Host A to Host C.
- From Host C to S1.
- From Host A to S1.
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started