Activity Machine setup Parts handling Quality inspections Total budgeted overhead Unit Information Units produced Budgeted Cost Activity Driver $ 26,000 (20 machine setups) 20,800 (16,000 parts) 31,200 (100 inspections) $ 78,000 Product A 2,600 units Product 520 units Direct labor cost Direct materials cost $ 36 per unit $ 46 per unit $ 56 per unit 2 per unit $ 66 per unit 2.50 per unit Direct labor hours 1. Using a plantwide overhead rate based on 6,500 direct labor hours, compute the total product cost per unit for each product. 2. Consider the following additional information about these two products. If activity-based costing is used to allocate overhead cost, (a) compute overhead activity rates, (b) allocate overhead cost to Product A and Product B and compute overhead cost per unit for each, and (c) compute product cost per unit for each. Actual Activity Usage Setups Parts Inspections Product A Product B 8 setups 10,000 parts 48 inspections 12 setups 6,000 parts 60 inspections Complete this question by entering your answers in the tabs below. Required 1 Required 2 Using a plantwide overhead rate based on 6,500 direct labor hours, compute the total product cost per unit for each product. Per Unit Direct Materials Direct Labor Overhead Product Cost per Unit Product A Product B Fuired 1 Required 2 > a. Compute overhead activity rates Activity Machine setup Parts handling Quality inspection Activity Rate per setup per part + per inspection b. Allocate overhead to Product A, B and compute overhead cost per unit Activity Machine setup Parts handling Quality inspection Total allocated cost Units produced Overhead cost per unit 69 Allocated Cost Product A Product B c. Product cost per unit using activity-based costing Per Unit Product A Product B Product Cost per Unit 0 $ 0