Activity-Based Costing Zeus Industries manufactures two types of electrical power units, custom and standard, which involve four factory overhead activities-production setup, procurement, quality control, and materials management. An activity analysis of the overhead revealed the following estimated activity costs and activity bases for these activities: Activity Activity Cost Activity Base Production setup $ 84,000 Number of setups Procurement 138,000 Number of purchase orders (PO) Quality control 168,000 Number of inspections Materials management 120,000 Number of components Total $510,000 The activity-base usage quantities for each product are as follows: Setups Purchase Orders Inspections Components Unit Volume Custom 500 850 1,700 350 2,000 Standard 200 350 700 250 2,000 Total 700 1,200 2,400 600 4,000 a. Determine an activity rate for each activity. Activity Rates Production Setup Procurement Quality Control Materials Management Activity cost $ $ Activity base Activity rate /setup s PO $ /inspection $ /component b. Assign activity costs to each product and determine the unit activity cost, using the activity rates from part (a). Round unit costs to the nearest cent. Custom Standard $ Setups Total Purchase Orders Total Inspections Total Components Total $ Total product cost Unit volume $ Unit cost C. Assume that each product required one direct labor hour per unit. Determine the per-unit cost if factory overhead is allocated on the basis of direct labor hours. Round your answer to the nearest cent. per unit $ d. The custom product will consume materials management activities than will the standard product