ARM assembly instructions have a similar format as Intel x86 instructions. One difference is that ARM assembly language instructions such as Add, SUB, MUL etc. _____ have instruction uses (how many?) source objects. For example, a MUL R4, R3, R2 have ____ (how many?) source, and as the destination. There are 40 pins in the original 8086 microprocessor. Write the name of the pin from the list below) that best matches the given description. Use the minimum mode signal designations for this problem. Each term is used no more than once, and not all of the terms will be used. ____ If this pin is active, the databus is being read into the CPUs internal data bus. ____ Works with the WAIT instruction: is set when the wait instruction is executed. _____ If the pin is low then the CPU will idle. When high, the CPU is 'ready' ____ Interrupt request pin, and is set (1) when an external interrupt is present Non-maskable interrupt (signals ignore the interrupt flag). When this signal is active, the CPU will use interrupt vector 2..... used for gnarly interrupts. ____ If this pin is high for at least 4 clock cycles, the CPU is reset. _____ this pin selects the mode of processing _____ used to demultiplex the address/data bus: active high enable control signals gnarly interrupts. that the multiplexed A/D bus bits 15 through 0 contain address information ____ when happy and content, a soft motor-type of sound can be heard from this Heartbeat of the CPU ____ Vcc ____ Power ____ ground You are working on some code, modifying the code that someone else When the following near procedure executes, what happens