As a dialysis patient, Michelle has a 4-h dialysis treatment three times a week. When she arrives at the dialysis clinic, her weight, temperature, and blood pressure are taken and blood tests are done to determine the level of electrolytes and urea in her blood. In the dialysis center, tubes to the dialyzer are connected to the catheter she has had implanted. Blood is then pumped out of her body, through the dialyzer where it is filtered, and returned to her body. As Michelle's blood flows through the dialyzer, electrolytes from the dialysate move into her blood, and waste products in her blood move into the dialysate, which is continually renewed. To achieve normal serum electrolyte levels, dialysate fluid contains sodium, chloride, and magnesium levels that are equal to serum concentrations. These electrolytes are removed from the blood only if their concentrations are higher than normal. Typically, in dialysis patients, the potassium ion level is higher than normal. Therefore, initial dialysis may start with a low concentration of potassium ion in the dialysate. During dialysis excess fluid is removed by osmosis. A 4-h dialysis session requires at least 120L of dialysis fluid. During dialysis, the electrolytes in the dialysate are adjusted until the electrolytes have the same levels as normal serum. Initially the dialysate solution prepared for Michelle contains the following: HCO3,K+,Na+,Ca2+,Mg2+,Cl, glucose. ACaCl2 solution is given to increase blood levels of calcium. If a patient receives 4.4mL of a 11% (m/v) CaCl2 solution, how many grams of CaCl2 were given? Express your answer to two significant figures and include the appropriate units