as In the following system design aload. controllen such that the damping ratio of complex poles be o.f and wamp erron constant be 80. Ress & CCS) - Sist 48.5) https://ms.tu.edusa/webapps/assessment/take/launch jsp?course_assessment id=65863_18.course_id = 240779_1&.content ide 8 Instructions Timed Test This test has a time limit of 1 hour. This test will save and submit automatically when the time expires. Warnings appear when half the time, 5 minutes, 1 minute, and 30 seconds remain Multiple Attempts Not allowed. This test can only be taken once. Force Completion This test can be saved and resumed at any point until time has expired. The time will continue to run if you leave the test. Remaining Time: 59 minutes, 43 seconds. Question Completion Status: Moving to another question will save this response. Question 1 of 4 Question 1 5 points Design a lead compensator for the system shown in figure (4), such that the damping ratio of complex poles be 0.7 and ramp error constant 0.85. Glears)=106.066 s +30 s+44.432 O Glear(s)-106.066 S+40 5 +64.432 5+20 Gleads)=706.066 S +84.432 O None Figure (4) docx.pdf ENG te HUAWEI R(S) C(s) Glead(s) 3(3+2) s(s+4)(8 +8) Figure (4) as In the following system design aload. controllen such that the damping ratio of complex poles be o.f and wamp erron constant be 80. Ress & CCS) - Sist 48.5) https://ms.tu.edusa/webapps/assessment/take/launch jsp?course_assessment id=65863_18.course_id = 240779_1&.content ide 8 Instructions Timed Test This test has a time limit of 1 hour. This test will save and submit automatically when the time expires. Warnings appear when half the time, 5 minutes, 1 minute, and 30 seconds remain Multiple Attempts Not allowed. This test can only be taken once. Force Completion This test can be saved and resumed at any point until time has expired. The time will continue to run if you leave the test. Remaining Time: 59 minutes, 43 seconds. Question Completion Status: Moving to another question will save this response. Question 1 of 4 Question 1 5 points Design a lead compensator for the system shown in figure (4), such that the damping ratio of complex poles be 0.7 and ramp error constant 0.85. Glears)=106.066 s +30 s+44.432 O Glear(s)-106.066 S+40 5 +64.432 5+20 Gleads)=706.066 S +84.432 O None Figure (4) docx.pdf ENG te HUAWEI R(S) C(s) Glead(s) 3(3+2) s(s+4)(8 +8) Figure (4)