Answered step by step
Verified Expert Solution
Question
1 Approved Answer
Assignment 1 : VL AN Configuration and Trunking Objective: The objective of this assignment is to configure VLANs and trunking on two Cisco switches, S
Assignment : VL
AN Configuration and Trunking
Objective: The objective of this assignment is to configure VLANs and trunking on two Cisco switches, S and S to segregate network traffic and enable communication between VLANs.
EquipmentSoftware Needed:
Two Cisco switches Sand S
Console cables
Terminal emulation software eg PuTTY
PCs PC PC PC PC
Ethernet cables
Topology:
Tasks:
Note: Switch is S and Switch is S
Initial Configuration:
On Switch S:
Set the hostname to OLDMAIN.
Set the enable secret password to "CTIRSUCO".
Create a local user "anthony" with the password "CTIRSUCO$
VLAN Configuration:
On Switch S:
Create VLAN named "SALES."
Create VLAN named "TECH."
Verify the VLAN configuration using the "show vlan brief" command.
Configure Gigabit Ethernet interfaces Gig and Gig as access ports in VLAN and respectively.
Verify the VLAN and interface configuration again.
On Switch S:
Set the hostname to HOL.
Set the enable secret password to "CTIRSUCO".
Create a local user "anthony" with the password "CTIRSUCO$
More VLAN Configuration on S:
On Switch S:
Create VLAN named "SALES."
Create VLAN named "TECH."
Configure Gigabit Ethernet interfaces Gig and Gig as access ports in VLAN and respectively.
Verify the VLAN configuration.
Save the configuration on S
Configuring Trunking:
On Switch S:
Configure interface Gig as a trunk port.
Remove the access VLAN configuration on Gig
Allow VLANs and on the trunk port.
Set the native VLAN to
Save the configuration.
On Switch S:
Configure interface Gig as a trunk port.
Remove the access VLAN configuration on Gig
Allow VLANs and on the trunk port.
Save the configuration.
Verification:
Assign the same IP address in Exercise to the PCs
Verify the VLAN and trunking configurations on both switches using appropriate show commands.
Ensure that PCs in VLAN can communicate with each other and PCs in VLAN can do the same.
Test interVLAN communication between PCs in VLAN and PCs in VLAN
Cleanup and Conclusion:
Save the final configurations on both switches and submit your pkt file
Write a page report summarizing the results and key takeaways from this assignment.
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started