Assignment Details Part A. The Conversion Cycle. [Up to 500 words] The Strategic Information System for Business and Enterprise HI5019 T1 2022 provide sufficient background knowledge to understand accounting information systems and analyse the transaction processing system. Based on the same strict assumption we apply in the H15019 T1 2022 individual assignment, we assume that this knowledge enables you to start an accounting consultancy. You are passionate to provide consultancy services in your area. To pursue your passions, you started your consultancy services. Luckily, you got your first client, Mrs Maria, head of the accounting department of ERPGATO Manufacturing Limited (EML). She requested you to provide her with an expert opinion on the components of overhead and the logical cost driver. For this expert opinion, she forwarded you the following information. For years, EML has allocated overhead based on total machine hours. A recent assessment of overhead costs has shown that these costs are now more than 45 per cent of the company's total costs. Sara is specifically worried about this variance, and as a managing director, she is trying to control overhead better. For this purpose, the head of the management accountant adopted an activity-based costing system. Each cutting board goes through the five processes. These processes are elaborated on in the following paragraph. To better control overhead, EML is adopting an activity-based costing system. Each cutting board goes through the following processes. The given data reveals that cutting is the first process. In this process, boards are selected from inventory and are cut to the required width and length. Imperfections in boards (such as knots or cracks) are identified and removed. The second process is assembly. In this process, cut wooden pieces are laid out on clamps, a layer of glue is applied to each piece, and then glued pieces are clamped together until the glue sets. The third process is shaping. Once the glue has been set, the boards are sent to the shaping process, where they are cut into specific shapes. After being shaped, the cutting boards must be sanded smooth. In this setting, sanding is the fourth process. The fifth process is finishing. In this process, sanded cutting boards receive a coat of mineral oil to help preserve the wood. The last process is packing. In the packing process, finished cutting boards are placed in boxes of 12. The boxes are sealed, addressed, and sent to one of the kitchen stores. Required: Suggest the most suitable component of overhead for EML. Further, determine a logical cost driver for each process