Answered step by step
Verified Expert Solution
Question
1 Approved Answer
AVR Programming Need to convert this set of code into assembly without using arduino libraries. PIR sensor tester l choose the pin for the int
AVR Programming
Need to convert this set of code into assembly without using arduino libraries.
PIR sensor tester l choose the pin for the int ledPin 13 LED int inputPin = 2; PIR sensor) int pirState LOW motion detected int val = 0; status Ichoose the input pin (for I we start, assuming no /l variable for reading the pin void setup0 pinMode(ledPin, OUTPUT; declare LED as output declare sensor as pinMode(inputPin, INPUT); nput Serial.begin(9600) void loopO val = digitalRead(inputPin); // read input value if (val HIGH)lcheck if the in 1S HIGH digital Write(ledPin, HIGH); turn LED ON if (pirState LOW) we have just turned on Serial.println("Motion detected!) We only want to print on the output change, not state pirState HIGH: else f digitalWrite(ledPin, LOW);turn LED OFF if (pirState HIGH) we have just turned of Serial.println("Motion ended!"); /f We only want to print on the output change, not state pirState = LOW
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started