Based on the table below, which of the statements below is/are correct regarding the 3D printing process shown in the schematic? a. This process is best suited for the Ibw volume production of tubes, bars and beams due to the nature of the extrusion process b. You can print thermoplastic and thermoset polymers with this process, you only need to make sure that the nozzle specs and the crosslinking conditions match the polymer requirements c. Manufacturing a thermoplastic HDPE hose with an extrusion nozzle heated to 175C is possible with this process d. You can use this process to print plastic or brittle objects but not elastomers and rubbers e. You can produce a room-temperature non-fragile 225 C oven-safe food container with at least one material from the above table using this process and a 280C nozzle