.BEGIN LOAD X ADD Y ADD Z STORE OUT X HALT X: DATA 0 Y: DATA 2 Z: DATA 3 END Desk check the above assembly program. Show the values of all the labelled data locations, the R register, and any output using the table below. If a value changes, enter the value in the next cell on the same row R: ? X: 0 Y: Z: 2. 3 OUTPUT: At the HALT instruction in the program above, what are the values of condition codes GT, LT, and EQ? Answer using the table below. You should assume that at the start of the program all condition codes are 0. GT: LT: E