Calculate the acceleration for the two sets of data you recorded using the expression for acceleration you determined in Post-Lab Question 4, and compare these values to those obtained by measuring distance and time using percent error. Cite two factors that may cause discrepancies between the two values. Calculate the Tension in the string for the falling washers for both procedures and fo_r the one where the masses were equal. Use the expression for the Tension derived in Post-Lab Question 4. Show all calculations. From these two values, and the one where the masses were egual. what trend do you observe in the Tension in the string as the acceleration increases? Mass of 15 0.06 Average Mass 0.004 Washers (kg) of Washer (kg) Procedure 1 Motion Data Mass of M1 (7 washers): 0.028 Mass of M2 (8 washers): 0.032 Height (m): 0.457m Trial Time (s) 1.33 2 1.28 3 1.31 4 1.35 5 1.37 Average 1.33 Average Acceleration (m/s?) 0.26m/s2Procedure 2. Motion Data Mass of M1 (6 washers): 0.024 Mass of M2 (9 washers): 0.036 Height (m): 0.457mTrial Time (s) 1.03 NO 1.01 1.06 4 1.04 5 1.01 Average 1.03 Average Acceleration (m/s?) 0.43m/s2