Calibri (Body) 11 Paste BIU ab x, x AA ndo Clipboard A A AaA ENT Find Normal No Spacing Heading 1 Replace Dictate Sensitivity Editor Reuse Select Files Font Paragraph Styles Editing Voice Sensitivity Editor Reuse Files Page 1 of 1 Requirements Configure OSPF for the lab network shown in the figure. However, do not use the traditional configuration with network commands in OSPF configuration mode. Instead, use OSPF interface configuration. The specific rules for this lab are: Configure so each router uses a router-id of xxxx where x equals the router number. Do not rely on interface IP addresses for the setting of the router IDs. Use OSPF area 0 for all interfaces Enable OSPF directly on each interface, rather than using the indirect method and the OSPF network command Assume all interfaces shown in the lab are up and working 172.21.1. 172.22.2.0/28 00/3 003 30'1 172.30 1.000 002 R1 30/2 R2 172.30.1.8/30 00/1 002 R3 172.23.3.0/27 172.30.1.4/30 Deliverables: Show running configuration or Screenshot of your results O words B French (Canada) Accessibility Investigate Display Settings Focus 100%