Answered step by step
Verified Expert Solution
Question
1 Approved Answer
can you answer all 8 if not then 4-8. thank you 1. (12 points) Consider a router that has the following Routing Table contents. For
can you answer all 8 if not then 4-8. thank you
1. (12 points) Consider a router that has the following Routing Table contents. For parts (a) - (d), answer with Fa0/0, Fa0/1 or Fa0/2. Destination Subnet Outgoing Next Hop Interface 99.111.30.32/27 Fa0/0 118.2.77.4 99.111.16.0/20 Fa0/1 59.16.1.1 0.0.0.0/0 Fa0/2 18.12.52.43 a) A packet with destination IP address 99.111.30.70 arrives to this router. Out what interface will this packet be sent? b) A packet with destination IP address 99.111.30.60 arrives to this router. Out what interface will this packet be sent? c) A packet with destination IP address 99.111.32.5 arrives to this router. Out what interface will this packet be sent? d) A packet with destination IP address 99.111.30.34 arrives to this router. Out what interface will this packet be sent? 2. (5 points) Assume that a router has learned 2 different possible routes to a destination network, called Routel and Route2. Assume that Routel has a lower Administrative Distance than Route2, but Routel has a higher Metric than Route2. Which route will this router put into its routing table for this destination network? 3. (5 points) What is the default Administrative Distance for a static route? 4. (8 points) On a Cisco router, from global configuration mode, I enter these commands: interface Fa0/1 ip address 42.16.7.53 255.255.255.240 no shutdown These commands add a new Connected route (type 'C') into the routing table. What are these values for this new route in the routing table: a) Destination Subnet (including network address and prefix length) b) Outgoing Interface c) Administrative Distance 5. (5 points) What is a Floating Static Route? Why would you use one? 6. (5 points) When a Cisco router sends a packet out a Serial interface, what is the name of the Layer 2 protocol used by default for the Layer 2 (MAC) packet header? 7. (5 points) Explain one advantage of using Point-to-Point Protocol (PPP) rather than High- level Data Link Control (HDLC) protocol for packets going over serial links. 8. (5 points) Name one advantage of implementing Dynamic Routing rather than Static RoutingStep by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started