Classic Accessories manufactures auto roof racks in a two-stage process that includes shaping and plating. Steel allow is the best raw material of the shaping process. The steel is molded according to the design specifications of automobile manufacturers (Ford and General Motors). The Plating Department then adds an anodized finish. At March 31, before recording the transfer of cost from the Plating Department to Finished Goods Inventory, the Classic Accessories general ledger included the following account: Work in Process Inventory - Plating March 1 balance 26,370 Transferred in from Shaping 28,800 Direct materials 28,600 Direct labor 20,867 Manufacturing overhead 36,763 The direct materials (rubber pads) are added at the end of the plating process. Conversion costs are incurred evenly throughout the process. Work in process of the Plating Department on March 1 consisted of 600 racks. The $26,370 beginning balance of "Work in Process- Plating" includes $14,400 of transferred in cost and $11,970 of conversion cost. During March, 3,000 racks were transferred in from the Shaping Department. The Plating Department transferred 2,200 racks to Finished Goods Inventory in March and 1,400 were still in process on March 31. This ending inventory was 50% of the way through the plating process. 1. Draw a time line for the Plating Department. 2. Prepare the March production cost report for the Plating Department. 3. Journalize all transactions affecting the Plating Department during march, including the entries that have already been posted