Question
Commands for topology in cisco packet tracer Task 1 - Topology Build You must build a topology in Packet Tracer to reflect your solution to
Commands for topology in cisco packet tracer
Task 1 - Topology Build You must build a topology in Packet Tracer to reflect your solution to the requirements. Note that you will need to complete some of the later tasks to finish this one. Components to use: Edge/Access switches: 2960 Distribution switches: 3650 Using a 3650 is different than we have done in the past when weve used a 3560 for distribution. There are two reasons for that. One is the IOS version is newer on the 3650, which makes the command output more consistent. Second is the 3650 has 1Gbps ports which means the uplinks can be gigabit. Before you configure a 3650, you must power it on. That involves dragging a power supply to the empty slots in the Physical view. Routers: 2911 Endpoints: Generic PCs Requirements: The headquarters must have three edge switches: one dedicated to the business datacenter and two for everything else. The engineering and test building must have three edge switches: one dedicated to the engineering datacenter and two for everything else. Both buildings will have a distribution switch. The edge switches at both buildings will connect to their respective distribution switches using a twointerface bonded channel. The distribution switches will be connected to each other using a two-interface bonded channel. The headquarters building will have a single router, that provides a connection to the Internet, connected to the distribution switch using a two-interface bonded channel. The ISP will have one router with a single interface connection to the headquarters building router. All network device names must contain your initials as they appear on the class list (e.g. BusinessHQSWEdge01-MK). Device names missing this requirement will constitute a major error. All hostnames must match the device names. Endpoints are not required, but you may create what you feel you need for testing to ensure everything works correctly. Screenshots Include one screenshot showing your topology.
Task 2 - VLANs You must determine the required VLANs and configure them as per the following requirements. A VLAN is required for each department at each site A VLAN is required for Staff WiFi A VLAN is required for Guest WiFi A VLAN is required for the business datacenter A VLAN is required for the engineering datacenter Use best practices for unassigned ports VLAN names must include your initials |3 Applied Networking and Security Assignment 1|Conestoga College |Winter 2023 Determine what VLANs are needed to meet the above requirements. Configure the VLANs on all switches. Trunk the inter-switch links. Do not channel bond the inter-switch links yet. Other than the datacenter, which is dedicated to a single switch, ensure that there is a minimum of one port assigned to each edge switch for each VLAN of the respective building
Step by Step Solution
There are 3 Steps involved in it
Step: 1
Get Instant Access to Expert-Tailored Solutions
See step-by-step solutions with expert insights and AI powered tools for academic success
Step: 2
Step: 3
Ace Your Homework with AI
Get the answers you need in no time with our AI-driven, step-by-step assistance
Get Started