Comment on whether your In vs Vos curves and In vs Vas curve are as expected. Explain the shape of the curves of In vs VDS as VDS increases. Where appropriate, compare your results to manufacturer specification: determine the slope of the plot of In vs Va for VG > Vr (linear region). Compare against the tolerances provided in the datasheet. (Note that transistor parameters can vary dramatically, and therefore values of Vr and gfs may been significantly different than typical values and still fall within specification.) Note that in our code we have intentionally "pulsed" our MOSFET on for a few millisec- onds at a time to take measurements, and then powered Vos or Ve off for some length of time. Why is this recommended for our measurements? Refer to the MOSFET specification sheet in your