Complete the state table below by carrying out these steps A. For the registers, show each value where it changes. Show the PC at the end of the instruction (ready for the next instruction). B. Show 0,1 or ?-? for flags on each line. Pay special attention to to the flags touched by the MOVF instruction. C. Show final values for all registers and the flags Symbols are defined by: ii Constants section Val01: EQU 0x25 Val02: EQU OxA7 ;; Variables section PSECT udata_acs Var01: DS 1 Var02: DS 1 State table: State Table: W $85 PC $0020 SP $00 0x00 SBB Ox01 $CC 0x02 $DD NOV Z C 0 100 Initial Values: MOVE Var01,W ADDWF Var02,W ADDWF Var02,F MOVLW Val02 SUBWF Var02,F Final Values: Symbol values: Var01: 0x000, Var02: 0x001 Note: Var01 is address Ox00, Var02 is address Ox01