Configure the hostname on all devices per the diagram. Disable DNS based address resolution and enable synchronous logging. Add interface descriptions as appropriate. Parts 1 and 2 Topology G101.4 Food-Sw VLANS: G110121-22 BBQ Soda 802.1Q Management Native Blackhole G110121-22 B 61011-4 Cafe-Sw BBQ Soda G1023-24 802.1Q G110123.24 Beverage-Sw Part 1: Network Addresses IPv4: Use 150.x.16.0/21 for your IPv4 network addressing. IPv6 Use site prefix 2001: DB8:x::/48 in all IPv6 networks Assign a different subnet id (4 hextel) with a 164 prefix to the BBQ LAN and the Soda LAN Network BBQ* Soda Management Food-Sw to Edge-Rtr Beverage-Sw to Edge-Rtr *IPv4 FHRP Size 125 500 15 2 2 IPv4 IPv6 No IPv6 Ink-local only link-local only Part 2: Layer 2 Configuration Important: Build and test the 3 inter-switch inks before continuing to Part 3. Do not build the connection to the core layer at this time. PCs will not be able to get addresses or connectivity until Part 3 Switches . Configure all VLANs Configure trunk links where needed and use the native VLAN between switches Configure an address in the Management VLAN Layer 3 Switches Food-Sw and Beverage-Sw Set up inter-VLAN routing on both switches for the BBQ, Soda, and Management networks EtherChannel Food-Sw to Cafe-Sw: Food-Sw should initiate the port channel Beverage-Sw to Cafe-Sw: Beverage-Sw should initiate the port channel using a different protocol from the other link Food-Sw to Beverage-Sw: statically set the port channel to always be on Spanning Tree Configure 802.1w on each switch Configure Food-Sw as the primary root for the BBQ and Management networks with Beverage-Sw as the secondary Configure Beverage-Sw as the primary root for the Soda network with Food-Sw as the secondary FHRP Configure an FHRP protocol on Food-Sw and Beverage-Sw Create groups for the BBQ and Soda networks Food-Sw should be the active gateway for the BBQ network Beverage-Sw should be the active gateway for the Soda network If the active gateway fails and recovers, it should resume the active role If the standby gateway's priority becomes the highest, it should assume the active role. Part 2 Verification PCs will not be able to get addresses or connectivity until Part 3. Each switch has a port channel, and all connected links are up. Food-Sw is the FHRP active router and spanning tree root for the BBQ network. Beverage-Sw is the FHRP active router and spanning tree root for the Sada network. Cafe-Sw can ping each address on Food-Sw and Beverage-Sw