Consider the following topology. R2 is the ISP router, and Ri is the customer router. The customer is assigned 12.0.2.224/29 as the public IP pool that can be used. Assume that the NAT on the customer router's interfaces are activated Customer SO/0/0 ISP S1 SO/0/1 R1 Fa0/11 Fa0/0 Fa0/10 R2 Fa0/0 Fa0/1 SW1 Gi0/1 Gio/1 SW1 SW2 Fa0/2 PC3 a) Create an address pool for dynamic NAT for the 12.0.2.225 to 12.0.2.229 network. Use a pool name of general. (5 points) b) Create an access list 100 on the Customer router that defines the NAT network. Last the router prompt and the command used to complete this task. You will allow only the network 172.15.0.0/24. (s points) e) Configure NAT inside on the Customer router using the previously defined overload source pool of addresses. You need to reference your source pool of addresses defined by the access-list 100. List the router prompt and the command used to complete this task. (5 points) d) Consider that you have a server St in the Customer network. You dedicate the public IP 12.0.2.230 for server Si. Configure the statie NAT IP on the Customer router for server S1. The static IP address for the server Si is 192.15.0.1. (s points) Consider the following topology. R2 is the ISP router, and Ri is the customer router. The customer is assigned 12.0.2.224/29 as the public IP pool that can be used. Assume that the NAT on the customer router's interfaces are activated Customer SO/0/0 ISP S1 SO/0/1 R1 Fa0/11 Fa0/0 Fa0/10 R2 Fa0/0 Fa0/1 SW1 Gi0/1 Gio/1 SW1 SW2 Fa0/2 PC3 a) Create an address pool for dynamic NAT for the 12.0.2.225 to 12.0.2.229 network. Use a pool name of general. (5 points) b) Create an access list 100 on the Customer router that defines the NAT network. Last the router prompt and the command used to complete this task. You will allow only the network 172.15.0.0/24. (s points) e) Configure NAT inside on the Customer router using the previously defined overload source pool of addresses. You need to reference your source pool of addresses defined by the access-list 100. List the router prompt and the command used to complete this task. (5 points) d) Consider that you have a server St in the Customer network. You dedicate the public IP 12.0.2.230 for server Si. Configure the statie NAT IP on the Customer router for server S1. The static IP address for the server Si is 192.15.0.1. (s points)