CONSIDER X=35.

Need this ASAP. And all questions answered. Previous questions posted are not the same or wrong! Thanks!

In this assignment, you will create and configure a network using the Packet Tracer network simulator. Classful Network Address: 199.20.X.0 {X has to be replaced with the following values based on the first letter of your first name - A to E: 18, F to J:21, K to O:27,P to T:35, U to Z:43. For example, if the name is John Doe then X=16, i.e. 199.20.21.0 \} Network Topology TABLE 1: The list of subnets and their network addresses and subnet masks TABLE 2: The list of devices, interfaces, and their addresses and subnet masks 1. a. (6 marks) Create the above network topology in Packet Tracer. Use router model 2911 and switch model 2960. Display interface labels (for example G0/0, 50/0/1) if they are not already displayed. Change the router name labels as shown above. Add subnet labels indicating the subnet name, subnet address, and SNM (in CIDR) using the format 'SUBNET name: address /SNM' (for example, ACCOUNTING SUBNET: x.x.x.x / n ). Add your name (first and last) in the top left corner. b. Take a screenshot of the topology and insert to your Word document. Make sure the screenshot clearly shows the topology and the labels. 2. (10 marks) Configure router RA: a. (1) Change name of the router to RA as shown in the diagram. b. (6) Configure the router interfaces as given in Table 2 above with X replaced as specified above. i. The IP addresses and SNM and turn it on ii. Description for each interface indicating the name of the subnet to which it is connected (e.g. Connected to Accounting Subnet) c. (2) Configure the console, vty, and the two privileged mode passwords as 'cisco' d. (1) Configure the motd banner "This router was configured by " e. Copy the router's running configuration file to a new page in the Word document while keeping the source formatting, add an appropriate title, remove all comment lines (lines starting with '!'), and highlight all configuration changes you made 3. Configure router RB: a. Configure the router interface IP addresses and SNM and as given in Table 2 above, and turn it on. 4. (4 marks) Verify interface status of each router a. For each router, use the command "show ip interface brief" to display interface summary b. Copy the outputs to a single page in the Word document, add the name of the router above each output and an appropriate title at the top of the page 5. (2 marks) Configure PC's a. Configure IP address, SNM, and default gateway of each PC. b. Display the IP configuration using ipconfig /all in the command prompt c. Copy a screenshot of the IP configurations of each PC showing the relevant details of the active interface on a separate page with an appropriate title 6. (3 marks) Verify connectivity a. Ping from PC0 to PC1 b. Copy a screenshot of the dialog box showing the PC name, ping command, and the Ping results for each PC as shown in the figure below. If the PC name is not showing at the top (e.g. PCO), you will not receive marks for the pings All results should be together on a single page with an appropriate title